Publicité
Les langues disponibles
Les langues disponibles
To set the clock:
1.
The hour digits start flashing in the time display section.
2.
Use the + key to adjust the hours and then press SET key to go to the minute setting.
3.
The minute will be flashing. Press the + key to just the minutes.
4.
Confirm with the SET key and exit the setting mode.
Note :
The unit will still try to receive the signal despite a manual setting. When the signal is received, the
manually set time will automatically be replaced by the received time. During reception attempts, the DCF
tower icon will flash. If reception has been unsuccessful, the DCF tower icon will not appear but reception
will still be attempted.
ALARM SETTING:
Alarm icon (ON)
To set alarm:
1.
Press and hold ALARM for about 3 seconds until the alarm time display flashes.
2.
The hour digit and the alarm icon will be flashing. Press the + key to adjust the hour.
42
Alarm time
Publicité
