Publicité
Les langues disponibles
Les langues disponibles
SETTING UP:
Note: This weather station receives only one outdoor transmitter.
1.
First, insert the batteries into the Temperature transmitter. (see "Install and replace batteries in
the Temperature transmitter").
2.
Immediately after and within 30 seconds, insert the batteries into Weather station (see "Install and
replace batteries in the Weather station"). Once the batteries are in place, all segments of the
LCD will light up briefly. Following the time as 0:00 and the weather icon will be displayed. If these
are not displayed after 60 seconds, remove the batteries and wait for at least 10 seconds before
reinserting them.
3.
After inserting the batteries, the Weather station will start receiving data from the transmitter. The
outdoor temperature and the signal reception icon should then be displayed on the Weather station.
If this does not happen after 3 minutes, the batteries will need to be removed from both units and
reset from step 1.
4.
In order to ensure sufficient 433 MHz transmission however, this should under good conditions be a
distance no more than 100 meters between the final position of the Weather Station and the
transmitter (see notes on "Mounting " and "433 MHz Reception ").
5.
Once the remote temperature has been received and displayed on the Weather station, the DCF
time (radio controlled time) code reception is automatically started. This takes typically between 3-5
minutes in good conditions.
32
Publicité
