Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
WATER DRAINAGE
1
When the internal drain pan becomes full the appliance will beep
8 times and the digital display will show error code P1. The air
conditioning or dehumidifying action will stop but the fan may
continue to operate.
Ensure that the appliance is turned off and unplugged and that it is
close to a fl oor drain before setting up any drain option.
1. Drain Plug
Remove the drain plug and allow the water to completely drain.
Replace the bottom drain plug, pressing fi rmly to ensure a tight fi t
and no leaks.
2. Continuous Drain
2
During dry mode, install continuous drain option so that the
appliance will automatically drain collected water.
Remove the upper drain plug and attach the drain hose that was
provided with the appliance. Place the open end of the drain hose
over the receptacle that the appliance will drain into; this could be a
basement fl oor drain, a sink or similar.
Ensure that there are no kinks or bends in the drain hose and
that it goes straight down toward the fl oor. The continuous drain
is activated by gravity only. If the hose is not positioned directly
downwards, water will not drain correctly.
3. Heat pump drain
During heat mode, install the heat pump drain so that the drain
3
pump can remove collected water from the appliance.
Remove the lower drain plug and attach the drain hose and adapter
that was provided with the appliance. Place the open end of the
drain hose over the receptacle that the appliance will drain into; this
could be a basement fl oor drain, a sink or similar.
The pump drain can be directed to a drain above the fl oor but must
not exceed a height of 1.8 meters (6 feet).
18
Publicité
