Roco EDK 750 Serie Manuel page 44

▪ Crane Settings
The Sounddecoder has been optimally adjusted to this crane. You can still adapt numerous
decoder properties to your wishes however. Certain parameters (referred to as CVs – Configu-
ration Variable – or register) can be amended.
Please check before each programming if this is really necessary. Incorrect settings can result in
the decoder not reacting correctly.
The decoder is preprogrammed with 28/128 speed steps at the factory for a high level of com-
fort. This means that it can be used together with all of the modern DCC (multiMAUS) and
Motorola control devices.
®
The Sounddecoder has been especially modified for the additional functions and must
not be replaced with a decoder which is available from a retailer.
If the crane is to be reprogrammed, only the crane is to be on the programming track.
▪ CV-list
CV Name
1 Address (= short address)
2 Minimum speed (lowest creeping speed)
3 Start-up delay (from standstill to maximum speed)
4 Braking delay (from maximum speed to stand-still)
5 Maximum speed
6 Medium speed (at medium running step)
Value 1 corresponds to 1/3 of Vmax. (CV 5)
7 Decoder Version Number (only read! Readable only on
reading-capable amplifiers/centres).
Important! Please note when using the multiMAUS in
order to achieve CVs greater than CV255: when underta-
king a short-term programming of CV7, only the subse-
quent programming access with the value 10 is increa-
sed by 100 CV places (meaning CV166 then accesses
CV266 for example). The value 20 is increased by 200
CV places.
8 Resetting of all values to the default settings; (With
908 readable amplifiers/controllers, the manufacturer ID is
readable)
17+ Long address (requirement: corresponding CV29 long
18 address setting is activated)
29 Settings
266 Total Volume of all Sounds
44
44
73037.indd 44 73037.indd 44
Value Default
Value
01 – 99 3
01 – 255 1
00 – 255 10
00 – 255 5
00 – 255 255
00 – 255 1
08 = Reset 145
100 – 9999
10
00 – 255 70
09.03.2022 07:16:21 09.03.2022 07:16:21