Symbols On The Product - Husqvarna 122C Manuel D'utilisation

5. Throttle trigger
6. Stop switch
7. Throttle trigger lockout
8. Spark plug cap and spark plug
9. Starter rope handle
10. Fuel tank
11. Air filter cover
12. Air purge bulb
13. Choke control
14. Operator's manual
15. Combination wrench
16. Starter housing
17. Shaft coupling
18. Bevel gear
19. Grease filler cap, bevel gear
20. Drive disc

Symbols on the product

WARNING! This product is dangerous.
Injury or death can occur to the operator or
bystanders if the product is not used
carefully and correctly. To prevent injury to
the operator or bystanders, read and obey
all safety instructions in the operator's
manual.
Read the operator's manual carefully and
make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Maximum speed of the output shaft.
The product agrees with the applicable EC
directives.
The product can cause objects to eject,
which can cause injury.
Keep a minimum of 15 m distance to
persons and animals during operation of the
product.
Use approved protective gloves.
1059 - 002 - 10.10.2019
Use heavy-duty slip-resistant boots.
Only use flexible cutting wire. Do not use
metal cutting attachments.
Noise emission to the environment refer to
the European Community's Directive. The
emission of the product is specified in the
Technical data chapter and on the label.
Air purge bulb.
Choke.
yyyywwxxxx
Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.
EPA III
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal and California emissions requirements.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week.
3