Eaton GH2 Manuel page 7

Dimensions
User information
Take care not to damage the enclosure. It the enclosure of the Multicolour Light is damaged, it may not be used.
While operating the Multicolour Light in business or industrial facilities, the legally required precautions against accidents
resulting from the use of electrical systems and devices must be taken.
Only a technical specialist may connect the Multicolour Light to the electric pcmer.
The Multicolour Light may only be operated under prescribed ambient conditions. Adverse ambient conditions may
damage the Multicolour Light.
Such adverse ambient conditions may be:
too high humidity (>90% rel., condensing)
•
moisture, dust (pay attention to the degree of protection)
•
inflammable gases, vapours, solvents
•
too high ambient temperatures (>60°C)
•
During operation of the Multicolour Light the ambient temperature range must not exceed nor fall below the prescribed
range of operating temperature.
The Multicolour Light disposes of a high light intensity. In order to prevent any visual impairment, avoid staring into the
activated light.
For version with AC voltage (230 VAC)
The Multicolour Light for AC voltage is constructed in insulation class. II and may only be operated at a voltage that lies
within the given voltage range.
An insulated power cable (e.g. LiYY 8x1.5 mm
Single conductors may not be used.
The constructor must install the appliance in such a way as to make sure it still fulfils insulation class II requirements
after installation.
Subject to alterations or errors
) must be used, and the insulation must be brought into the endosure.
2
GH2 ACTIVELINE BEACON TECHNICAL MANUAL
GH2 Activeline Beacon Technical Manual
Self-sealing grommet M16 x 1.5 for cable
diameters of 6–8 mm
Rated breaking point for cable diameters
up to 10 mm
TMF0074.A www.eaton.com
7