Gladiator Garageworks GATC26V9WG Instructions D'assemblage page 3

The Gladiator ® Garageworks Classic 5 Drawer Roll-Away is
designed to support a Gladiator
®
Chest and a Gladiator Classic 9 Drawer Chest stacked on top,
as shown on the cover.
Remove the tools from the drawers before stacking and
unstacking, and use two or more people to lift the tool
chests.
While using the tool chests, open only one drawer at a time
to avoid tipping.
Before moving the Roll-Away cabinet or Roll-Away cabinet
stacked with tool chests to a different location, make sure all
the drawers are closed and locked. Use the push handle to
move the Roll-Away cabinet.
Unpack the Cabinet
NOTE: Keep the packing materials to cushion the cabinet during
assembly and then dispose of/recycle all packaging materials.
1. Remove the cabinet, parts and fasteners.
2. Verify contents. See "Parts Supplied."
Install the Casters
IMPORTANT:
Both of the swivel casters with brakes must be installed on the
same side of the cabinet.
The swivel casters and the push handle must be installed on the
same side of the cabinet.
1. Using two or more people, place the cabinet on its top so that
the bottom of the cabinet is facing up, as shown.
2. Determine which side of the cabinet you want to install the swivel
casters.
3. Place a spacer over each of the four holes located in a corner of
the bottom of the cabinet.
4. Align the four holes in the caster plate with the spacers and holes
in the corner of the cabinet.
5. Using four 14 mm bolts for each caster, fasten the caster plates
to the bottom of the cabinet.
6. Repeat steps 2 through 4 to install the remaining casters.
7. Completely tighten the bolts. Using two or more people, stand
the cabinet upright.
A. 14 mm bolts
B. Swivel caster with
brake
Install the Push Handle
IMPORTANT: Install the push handle to the cabinet so that the
handle is on the same side as the swivel casters.
1. Insert the brackets on each end of the push handle into the slots
on the cabinet side.
2. Align the holes in the cabinet side with the holes in the brackets.
® Classic 3 Drawer Intermediate
A
B
C
D
C. Caster plate
D. Spacer
3. Using four 10 mm hex head bolts and washers, fasten the handle
brackets to the cabinet.
B
A
C
D
A. Push handle
B. Handle bracket
C. Slot
Complete the Installation
1. Unroll the drawer liners and place a liner in each of the drawers.
2. Place the pad on the top of the cabinet.
Use, Remove and Replace the Drawers
NOTES:
The key locks the roll-away cabinet and all of the drawers.
Use the drawer liners to avoid scratching or damaging the
drawer finish.
Removing the Drawer
1. Unload the contents from the drawer.
2. Slide out the drawer as far as it will go.
3. Press the lever down on the right-hand track and lift the lever up
on the left track to release the drawer. Pull the drawer out the rest
of the way.
Replacing the Drawer
1. Align the drawer guides with the receiving glides.
2. Hold the receiving glides firmly and insert the drawer guide.
NOTE: It is normal for the drawer to close tightly the first time
after it has been removed.
3. Push the drawer in completely.
E
D. 10 mm hex head bolt
E. Washer
A
A. Lever
3