Saving A Position; Saved Position; Change Display Indication - VITRA Tyde Mode D'emploi

Saving a position

EN
A specific desk height can be saved using this
function. Three different table heights can be
saved. These saved table heights can be reset at a
later point in time (see Moving into a saved positi-
on).
Moving to a desired table height. The current height
will be shown on the display (e.g. 73 cm).
Press the save button «S». The display will blink for
2 seconds. «S -» will appear on the display.
Push one of the desired saved position buttons
during this 2 second interval (e.g. «
appear on the display.
After approx. 2 seconds, the saved table height will
be shown (e.g. 73 cm).

Saved position

Press and hold one of the desired saved position
buttons (e.g. « ») until the table stops of its own
accord.
If the saved position button is released before the
stop position is reached, the desk will remain in the
current position.
20

Change display indication

This function can be used to change the height
shown on the display, but not the actual
position of the table top (e.g. when using a
different panel thickness than that included in the
pre-programmed information).
Note that this setting change does not alter the
actual position of the table top. It only affects the
height shown on the display.
Press and hold the «up» and «down» buttons
simultaneously for 5 seconds. «---» will initially
appear on the display and the display will then
»). «1» will switch back to the height display. Now set the
height using the «up» or «down» buttons.
After 5 seconds, the height display will then be set
to the table top position entered. The display will
blink once to confirm that the saving procedure was
successful. If you are unsure of the actual table top
height, we recommend you measure the height by
hand using a measuring tape.