Handset Description; Commissioning; Performing Reset; Height Adjustment - VITRA Tyde Mode D'emploi

Handset description

Up button Save button
Down button
Up button
Down button

Commissioning

Before using the table for the first time, you must
carry out a reset.
Display
Save position buttons
1-3

Performing reset

When you move your table down, it will
automatically stop just before the final position. The
table will then move into the final position at a much
slower speed. On reaching the final position, your
table will automatically shift back up slightly. To
reach the final position, push and hold the «down»
button until your table stops automatically. Repeat
this process afterwards.
As soon as your table has stopped in the final
position, release the «down» key for 2-3 seconds.
Then immediately press and hold the «down» key
for an additional 6-8 seconds. Your table will move
up and down slightly during the reset process.
Releasing the «down» button before the reset is
complete will abort the reset process and you will
have to repeat it. You cannot move your device up
if the reset process has been aborted. The «up»
button will not respond.

Height adjustment

To move your table, press and hold the «up» or
«down» button.
EN
19