Dualit DHB2 Manuel D'utilisation page 6

USING THE CHOPPER BOWL
& GEARBOX
With its sharp blades and capacity, the chopper bowl accessory is compact and
21 fl oz
handy for dry ingredients. For max loadings see chart on page 14.
1 INSERT BLADES 2 INGREDIENTS
Ensure the hand blender is Distribute ingredients evenly
unplugged. Insert the blade in the bowl. Pre-cut larger
in the chopper bowl; locate pieces of food into even
it over the chopper bowl sized cubes (approx 2cm).
shaft. Caution: blades Do not fill above the MAX.
are sharp! Note: Never put food in
before blade.
4 5
ATTACH TURN ON
GEARBOX
Attach the gearbox to the Plug in the hand blender.
centre of the lid. Align the Set the speed to
four protruding dimples. minimum (-), press the
power button to start
chopping.
3 CLOSE LID
Turbo
Turbo
Place the lid on the bowl
and rotate clockwise to lock.
Ensure lid is correctly
locked in place with the
feed tube and spout
aligned.
6
PULSE
Pulse for a maximum of 25
seconds for meats or tough
ingredients, 30 seconds for
liquids and soft ingredients.
Note: Use repeated short
pulses (no more than 1
second) for best results.
10
For best results short and regular 1 second pulses are recommended.
7 FEED TUBE 8 FEED TUBE
COVER
Ensure the hand blender is Replace the feed tube
unplugged. Remove the feed cover. Plug in the
tube cover and drop ingredients appliance and continue
down the feed tube. Never operating the hand blender.
reach into the feed tube
with your fingers or
utensils (e.g. a spatula).
REMOVE REMOVE LID
10 11
GEARBOX
Remove the gearbox from Rotate the lid anti-
the main body by twisting clockwise. If scraping out a
anti-clockwise. mixture take out the blades
first. Never touch the
cutting edges of the blades.
Caution: blades are
sharp!
Turbo
Turbo
9 TURN OFF
When chopping is complete,
release the power button
then unplug. Ensure the
motor and blades have
stopped then lift the main
body and gearbox vertically
off the chopper bowl lid.
CLEAN PARTS
12
Clean parts immediately
after use.
11