Programming A Password - TOOLCRAFT ST-100HF Mode D'emploi

If the temperature you entered is not within the permissible range (320 °C to 400 °C), "TEMP. ERROR"
will be displayed. You can enter the temperature again after a few seconds (wait until "MEAS TEM" is
displayed). Enter a temperature within the permissible range. If you do not know the correct value and wish
to exit calibration mode, switch off the soldering station (the previously entered temperature will not be
saved).
Start the calibration process again, but wait until the soldering tip has cooled down to room temperature
(see the instructions at the beginning of section 10. c).
• After a few seconds the display will revert to the main menu (see screenshot in section 10. a). To exit settings mode,
switch the soldering station off using the on/off switch.
e) Programming a password
• Press button "3" when the main menu is displayed (see section 10. a). "PASSWD. CHANGE" will appear briefly
on the display.
Subsequently, "OLD PASS 000" (= old password) is displayed.
• Use the three control buttons (2) to enter the old password. The default password is "000".
"1" = Decrease value
"2" = Choose input position
"3" = Increase value
If the password is set to "000", you will not be able to set a fixed soldering tip temperature (see section
10. b).
• Hold down button "2" to confirm your entry. The password will flash three times and "NEW PASS 000" will be
displayed.
• Use the three control buttons (2) to enter the new password.
"1" = Decrease value
"2" = Choose input position
"3" = Increase value
• Hold down button "2" to confirm your entry. The password will flash three times and "VERIFY P 000" will be dis-
played.
• Use the three control buttons (2) to enter the new password again.
"1" = Decrease value
"2" = Choose input position
"3" = Increase value
• Hold down button "2" to confirm your entry. The password will flash three times and "P CHANGE SUCCESS" will
be displayed.
• After a few seconds the display will revert to the main menu (see screenshot in section 10. a). To exit settings mode,
switch the soldering station off using the on/off switch.
Write the password down. If you forget the password, you can reset it to "000", but this requires you to open
the soldering station. This must only be done by people who are trained to repair electrical equipment. This
procedure is described in section 10. f).
43