Standby Mode; Power Saving Mode - TOOLCRAFT ST-100HF Mode D'emploi

• The soldering iron requires some time to reach the preset temperature. The status LED (8) flashes when the solder-
ing iron is heating up and reheating.
Smoke emitted from the soldering tip is the result of evaporating residual flux. Make sure that your work-
place is sufficiently ventilated (e.g. with an extraction system).
• After you have finished soldering, place the soldering iron back into the holder (11).
Fully insert the soldering iron into the holder so that it will not fall out by accident – fire and burn hazard!
c) Standby mode
The soldering iron automatically switches to standby mode when it is in the soldering iron holder (11) and has not
been used for approximately 20 minutes (the soldering iron has a built-in tilt sensor that detects when the soldering
iron is not in use).
In standby mode, the temperature drops to 200 °C to save energy and to protect the soldering tip.
"SET: STB" and "TMP:200" will appear on the display.
Warning!
If the preset temperature is lower than 200 °C, the soldering station will heat up to 200 °C when it is in

standby mode!

You can disable standby mode in two ways:
• Briefly press one of the three control buttons (2). The soldering station will return to the preset temperature (press-
ing the control button only disables standby mode and does not enable the corresponding temperature).
• Remove the soldering iron from the soldering iron holder (the built-in tilt sensor detects movement and disables
standby mode).
d) Power saving mode
The soldering iron automatically switches to power saving mode when it is in the soldering iron holder (11) and has not
been used for approximately 40 minutes (the soldering iron has a built-in tilt sensor that detects when the soldering
iron is not in use).
"zzZZZz.. RESTART" will appear on the display.
To disable power saving mode so that you can use the soldering station again, switch the soldering station off using
the on/off switch (1), and then switch it back on.
37