HP 9200c Digital Sender Guide De Mise En Route page 34

FCC regulations
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy. If this equipment is not
installed and used in accordance with the instructions, it can cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation; the presence of interference can be determined by turning the
equipment off and on. If this equipment does cause harmful interference to radio or
television communications, the user is encouraged to try to correct the interference by one or
more of the following measures:
●
●
●
●
NOTE Any changes or modifications to the device that are not expressly approved by HP could
void the user's authority to operate this equipment.
28 Chapter 3 Troubleshooting and customer support
All manuals and user guides at all-guides.com
Reorient or relocate the receiving antenna.
Increase distance between equipment and receiver.
Connect equipment to an outlet on a circuit different from that to which the receiver is
located.
Consult your dealer or an experienced radio/television technician.
ENWW