HP 9200c Digital Sender Guide De Mise En Route page 20

Step 6. Connect the power cord
1. Connect the power cord to the product power cord connector. Then connect the power
This product can operate using either 110/120 volts (V), 60 hertz (Hz) power or 220/240 V,
NOTE
50 Hz power.
2. Turn the product on by using the power button. After the product warms up, a prompt
14 Chapter 2 Setup
All manuals and user guides at all-guides.com
cord to an adequate alternating current (ac) outlet.
appears asking you to configure your control-panel display language (see
Configure the control-panel settings).
Step 7.
ENWW