Using The Auto Set Cs2; Starting Treatment; Stopping Treatment; Standby Mode - Resmed Autoset Cs 2 Mode D'emploi

U
SING THE
WARNING
!
Before starting therapy with a new mask, select the correct mask type in the
Settings menu (page 26). When adding or removing a new component such as a
mask, humidifier or anti-bacterial filter, perform the Air Circuit Learn function
(page 26).
S
TARTING
When the system is fully assembled, press the power switch at the back of the
A
generator is warming up. Allow the unit to warm up for approximately 30 seconds
before placing the mask on your face.
Figure 12: Welcome screen
Once the A
immediately. If not, press the Start/Stop key once to commence treatment.
The
S
TOPPING
If S
mask. If the S
S
TANDBY
Figure 13: Standby screen
Once you have stopped treatment, the A
standby you can:
•
•
•
When in standby mode, a gentle (non-therapeutic) flow of air will still be present.
If the SMART DATA - AUTO APPEAR option is set to ON, the screens available under the
N
OTE
Results menu will be displayed automatically for approximately 20 minutes after your
session is completed.
Get user manuals: See SafeManuals.com
A S
UTO
T
REATMENT
CS2 to ON. The Welcome screen will be displayed while the flow
S
UTO ET
WELCOME
CS2 has warmed up, breathing into the mask should start therapy
S
UTO ET
CS2 restarts in the mode in which it stopped.
A S
UTO ET
T
REATMENT
is enabled, treatment will stop automatically when you remove your
S
MART TOP
function has been disabled, press the Start/Stop key.
S
MART TOP
M
ODE
AUTOSET CS2
menu
press the power switch at the back to OFF to turn off the flow generator
commence treatment again by breathing into the mask or pressing the Start/
Stop key
enter any of the menus by pressing the Left key.
CS2
ET
CS2 will be in standby mode. In
S
UTO ET
U A S CS2
SING THE UTO ET
21