Kortel Design KRUYER III Notice D'utilisation page 44

Preparation for take-off
Connection in the harness
Once the pre-flight completed, it is time to settle in correctly
in the harness:
- Put on the harness
- Position the shoulder straps to keep the harness in place
Despite the presence of a closure system, we recommend
leaving the buckles closed and donning the harness, for
greater safety and to minimize the risk of forgetting an
attachment.
It is possible to open the leg loops to put on the harness, by
proceeding as follows:
- Thread the dyneema loop in the ring of the "Connect"
system.
- Pass the loop around the red pin
- Tighten the buckle
1
2
3
Just as much as the harness settings, the pilot's take-off gestures
Just as much as the harness settings, the pilot's take-off gestures
are crucial for ease of installation.
are crucial for ease of installation.
More detailed information is available at www.korteldesign.com. More detailed information is available at www.korteldesign.com.
44
KRUYER III