Publicité
Les langues disponibles
Les langues disponibles
Preparing your harness
Installation of the reserve parachute
The connection of the reserve risers to the shoulder loops can
be done in different ways:
« Kite loop »
A lark's head connection is considered correct when the 2 loops
A lark's head connection is considered correct when the 2 loops
are well centred to each other and tightened by hand as tightly as
are well centred to each other and tightened by hand as tightly as
possible. There should be no relative movement possible between
possible. There should be no relative movement possible between
the 2 parts.
the 2 parts.
« T-Bone Link »
Flexible connectors must not be used on straps wider than 25mm.
Flexible connectors must not be used on straps wider than 25mm.
For quick links, refer to the manufacturer's recommendations.
For quick links, refer to the manufacturer's recommendations.
« Quick links »
« Soft-Link »
41
It is imperative to choose connectors wisely. The dimensions
and shape must be adapted to the connecting straps of the
harness and to the reserve risers of the parachute, so that the
effort under load is applied in an optimal way.
A minimum resistance of 2400daN is imperative for any
A minimum resistance of 2400daN is imperative for any
connector used in the "reserve-lift" link. For the "risers-safety
connector used in the "reserve-lift" link. For the "risers-safety
harness" link: 1200daN
harness" link: 1200daN
When using a dirigible reserve parachute with integrated
risers,
these integrated risers must be connected directly. Shoulder
mounting can be carried out as described above.
Please refer to the manufacturer's installation and usage
precautions.
More detailed information is available at www.korteldesign.com.
More detailed information is available at www.korteldesign.com.
KRUYER III
Publicité
