Kortel Design KRUYER III Notice D'utilisation page 39

Preparing your harness
Accessoires
Speedbar installation:
To install the speedbar (optional), simply pass the cord
through the pulley located on the side of the harness, then
insert it into the ring located at the front of the thigh.
The speedbar adjustment is done at the level of the
adjustment pads. The best adjustment allows you to take
advantage of the entire speed range of the wing, when the
second rung is pushed out with your legs stretched out.
The speedbar should not be set too short. The wing must not be in The speedbar should not be set too short. The wing must not be in
the accelerated position without voluntary action of the pilot on
the accelerated position without voluntary action of the pilot on
the speedbar.
the speedbar.
2
3
39
KRUYER III
Speedbar
1
Speedbar pulleys
2
Speedbar passage ring
3
Speedbar cords
4
Adjustment pads
5
4
1
5