Connecting The Antennas; Connecting The Power Cord - Onkyo HT-R990 Manuel D'instructions

Connecting the Antennas

This section explains how to connect the supplied indoor FM antenna and AM loop antenna.
The AV receiver won't pick up any radio signals without any antenna connected, so you must connect the antenna to use
the tuner.
Push.
Assembling the AM loop antenna
AM loop antenna (supplied)
Note
• Once your AV receiver is ready for use, you'll need to tune into a radio station and position the antenna to achieve the best possible
reception.
• Keep the AM loop antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.
Tip
• If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available outdoor FM antenna instead.
• If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commercially available outdoor
AM antenna.

Connecting the Power Cord

1
Plug the power cord into an AC wall outlet.
En
20
Insert wire. Release.
North American models
Insert the plug fully
into the jack.
Caution
• Be careful not to injure yourself
when using thumbtacks.
Indoor FM antenna (supplied)
Note
• Before connecting the power cord, connect all of your
speakers and AV components.
• Turning on the AV receiver may cause a momentary power
surge that might interfere with other electrical equipment on the
same circuit. If this is a problem, plug the AV receiver into a
different branch circuit.
European models
Insert the plug fully
into the jack.
Thumbtacks, etc.