Connecting Onkyo U Components; Connecting A Recording Component - Onkyo HT-R990 Manuel D'instructions

Connecting Onkyo u Components

1
Make sure that each Onkyo component is
connected with an analog audio cable (connection
G in the hookup examples)
2
Make the u connection (see the illustration).
3
If you're using an RI Dock, or cassette tape deck,
change the Input Display
With u (Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
u while the AV receiver is on Standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
u, the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver's remote controller to
control your other u-capable Onkyo components,
pointing the remote controller at the AV receiver's
remote control sensor instead of the component. You
must enter the appropriate remote control code first
page 65).
(➔

Connecting a Recording Component

See "Recording" for details on recording
VCR, DVD recorder,
cassette tape deck,
CDR, MD recorder, etc.
(➔ page 17).
(➔ page 40).
(➔ page 40).
L R
AUDIO VIDEO
IN IN
e.g., CD player
RI Dock
Note
• Use only u cables for u connections. u cables are supplied
with Onkyo components.
• Some components have two u jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional u-capable components.
• Connect only Onkyo components to u jacks. Connecting other
manufacturer's components may cause a malfunction.
• Some components may not support all u functions. Refer to
the manuals supplied with your Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change u functions do not work.
Note
• The AV receiver must be turned on for recording. Recording is
not possible while it's in standby mode.
• If you want to record directly from your TV or playback VCR to
the recording VCR without going through the AV receiver,
connect the TV/VCR's audio and video outputs directly to the
recording VCR's audio and video inputs. See the manuals
supplied with your TV and VCR for details.
• Video signals connected to composite video inputs can be
recorded only via composite video outputs. For example, if your
TV/VCR is connected to a composite video input, the recording
VCR must be connected to a composite video output.
• The surround sound and DSP listening modes cannot be
recorded.
• Copy-protected Blu-ray Discs and DVDs cannot be recorded.
• Sources connected to a digital input cannot be recorded. Only
analog inputs can be recorded.
• DTS signals will be recorded as noise, so don't attempt analog
recording of DTS CDs or LDs.
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
En
19