Adjusting Trimmer For User; Fitting And Adjusting The Carrying System; Adjusting The Handle; Balancing The Brushcutter - Stihl Fsa 90 Notice D'emploi

9 Adjusting Trimmer for User

► Remove the rider plate, thrust washer, metal
cutting attachment and fanwheel.
► Remove stop pin.
9 Adjusting Trimmer for User
9.1 Fitting and Adjusting the Carry‐
ing System
1
2
► Put on the shoulder strap (1) or full harness
(3).
► Adjust the shoulder strap (1) or full harness (3)
so that the carabiner (2) is about a hand's
width below your right hip.
Other approved carrying systems are listed in
this User Manual,
9.2

Adjusting the Handle

FSA 90
The bike handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter, push the retaining
latch to position and remove the battery.
► Hook the brushcutter from the carrying ring
into the carabiner of the carrying system.
► Loosen the wing screw (1).
► Swing the bike handle (2) to the required posi‐
tion.
► Tighten down the wing screw (1) firmly.
FSA 90 R
The loop handle can be set to different positions
to suit the height and reach of the user.
► Switch off the brushcutter, push the retaining
latch to position and remove the battery.
0458-709-9621-D
3
2
22.
2
1
► Undo the screws (2).
► Move the loop handle (1) to the required posi‐
tion and check that the following conditions
are met:
– If you are using a mowing head: a = no
more than 30 cm
– If you are using a metal cutting attachment:
a = no more than 25 cm
► Tighten down the screws (2) so that the loop
handle (1) cannot be rotated on the shaft.
9.3

Balancing the brushcutter

The cutting attachment should rest lightly on the
ground.
► Switch off the brushcutter and push retaining
latch to position .
► Connect the carrying ring (1) to the carabi‐
ner (2).
► Wait for brushcutter to stop swinging.
English
a
1
2
1
2
39