Roborock Dyad Air Manuel Utilisateur page 9

Add the Device
On the Roborock App, tap "+" on the home page,
and add the device as instructed in the app.
Notes:
The actual process may vary due to ongoing app updates.
Follow the instructions provided in the app.
Only 2.4 GHz WiFi is supported.
If the vacuum cleaner waits more than half an hour for a
connection, WiFi will be automatically disabled. If you want
to reconnect, reset the WiFi before proceeding.
Instructions for Use
C
Filling the Clean Tank
C1
C1-1— Push the Clean Tank Release and
remove the tank.
C1-2— Open the plug, add enough clean water
to clean the required area and the water
level should not exceed the MAX line.
If deep cleaning, add the Roborock
floor cleaner diluted according to the
guidance on the cleaner bottle. Do not
add excessive cleaner.
C1-3— Reinstall the Clean Tank bottom first
then push forward to secure it in place.
Notes:
To avoid deforming the Clean Tank, only use cold water.
To prevent corrosion or damage, do not use any
disinfectant and only use detergent recommended by
Roborock.
Locking and Unlocking
C2
C2-1— Tap the side of the cleaning head, and
push the handle to lock the cleaning
head or pull the handle to unlock the
cleaning head.
C2-2— Locked
C2-3— Unlocked
Starting the Vacuum Cleaner
C3
Unlock the cleaning head, tilt the body and
press the power button to start the vacuum
cleaner.
C3-1— Do not tilt over 60°
Caution
C3-2—
In order to prevent dirty water from
leaking out, do not lay the body flat or
tilt it over 60° when dirty tank in place.
Notes:
The cleaning head does not work when locked. Unlock
it first.
Press power button can only start drying when the vacuum
cleaner is charging.
Switching Modes
Press the change mode button to switch to
AUTO, MAX, Floor Drying or ECO mode. The
screen will display the icon for the current
mode.
Notes:
Floor Drying mode is for removing clean water from wet
environments such as bathrooms. It should not be used
when water depth exceeds 10mm (0.4in).
Floor Drying mode is limited to one minute. After which,
AUTO mode will resume.
Adjusting the Splash Guard
C4
You can adjust the splash guard using the lift
toggle. You can raise it to collect large pieces of
waste on the floor and lower it to prevent the
cleaning head from getting stuck when there
are many objects on the floor.
09
Standby and Power Off
1. When the vacuum cleaner is operating, press
the power button to pause it and enter
standby mode.
2. In standby mode, you can lock the cleaning
head and place the vacuum cleaner upright
on the floor.
3. Lock the cleaning head and press and hold
the power button for 2 seconds to turn off
the vacuum cleaner. If the vacuum cleaner is
left idle for 5 minutes in standby mode, it will
automatically turn off.
Note: You can modify the settings in the app to enable auto-
matically resume operation after unlocking the cleaning head.
Adding and Emptying Water
When the dirty tank is full or the clean tank
is empty during use, the vacuum cleaner will
provide audio and visual alerts. Add water into
the clean tank or empty the dirty tank before
continuing.
Emptying the Dirty Tank
C5
C5-1— Push the dirty tank release and remove
the tank.
C5-2— Hold the handle firmly with one hand,
and gently lift out the cover.
C5-3— Pour out the dirty water. If there is any
solid dirt in the tank, filter it using the
filter at the bottom of the cover.
C5-4— Reinstall the cover, tilt the dirty tank,
install the bottom in place, and then
gently push it inward to secure it in
place.