Roborock Dyad Air Manuel Utilisateur page 10

Charging and Self-Cleaning
C6
1. Lock the cleaning head, and place the
vacuum cleaner onto the charging dock.
The voice alert "Charging" indicates that the
vacuum cleaner is charging.
2. Press the Self-Clean button to start standard
self-cleaning. Press and hold the clean
button for 2 seconds to switch to DEEP self-
cleaning mode.
3. After self-cleaning finishes, empty the dirty
tank to prevent odor.
Notes:
The product is equipped with a built-in high-performance
lithium-ion rechargeable battery pack. To maintain battery
performance, keep the product charged for normal use.
Always place the vacuum cleaner on the charging dock after
use to prevent water stains.
Drying
Drying starts automatically after self-cleaning
is completed. To manually start or stop drying,
press the power button on the docked vacuum
cleaner.
Voice Alert Settings
Connect to the app to adjust the volume of
voice alerts.
Routine
D
Maintenance
To maintain optimal performance of the
product, refer to the following table for routine
maintenance.
Maintenance
Parts
Frequency
Roller 2–4 weeks
Filter 1 month
Cleaning head
and dirty water 1 month
pipe
Dirty tank 1 month
Dirty water level
1 month
sensor
Charging dock
As needed
tray
Charging
1 month
contact
Product Maintenance
If this product is left unused for a prolonged
period of time, fully charge it and unplug it
before storing it in a cool and dry place. Do not
place the product in humid locations or under
direct sunlight. Charge it at least once every 3
months to avoid overdischarge.
10
Cleaning the Body
Wipe and clean the body with a soft and dry
cloth. Before cleaning, unplug the power
supply and keep the vacuum cleaner off.
Cleaning the Dirty Tank and
D1
Filter
Replacement D1-1— Take out the dirty tank, pull out the
Frequency
cover, and open the water level sensors.
Clean the parts with the provided
6–12 months
maintenance brush, rinse them with
6–12 months
cold water, and then snap the water
level sensors back in place.
D1-2— Take out the filter from dirty water tank
N/A
cover and remove any trash attached
to the filter. If the filter is dirty, rinse it
N/A
with cold water and then shake off the
residual water.
N/A
D1-3— Allow up to 24 hours for all parts drying
and install them back in place.
N/A
Notes:
Use a second filter if necessary.
Do not touch the filter with your hands, brushes, or sharp
objects to avoid damage to the filter.
N/A
Cleaning the Roller
D2
1. Remove the vacuum cleaner from the
charging dock, switch it off.
2. Place the vacuum on a hard and flat floor
and lock the cleaning head.
D2-1— Rotate the roller cover to the unlock
position, and pull the roller outward.
D2-2— Cut off any hair entangled on the
roller and remove any debris using the
provided maintenance brush.
Note: Use the maintenance brush carefully to avoid injury.