Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Appliance description
2.2
General safety instructions
WARNING Burns
During operation, the tap and safety valve can reach
temperatures in excess of 60 °C.
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
WARNING Injury
!
The temperature selector should only be removed by a
qualified contractor.
WARNING Injury
!
The appliance may be used by children aged 3 and older
and persons with reduced physical, sensory or mental
capabilities or a lack of experience and know-how, pro-
vided that they are supervised or they have been in-
structed on how to use the appliance safely and have
understood the resulting risks. Children aged 3 to 8 years
are only allowed to operate the tap connected to the
appliance.Children must never play with the appliance.
Children must never clean the appliance or perform user
maintenance unless they are supervised.
Where children or persons with limited physical, sensory or men-
tal abilities are allowed to use this appliance, we recommend a
permanent temperature limit. A qualified contractor can set this
limit.
Material losses
!
The user should protect the appliance, the water pipes,
the safety valve and the tap against frost.
Material losses
!
If the drain pipe of the safety valve is sealed, expanding
water can lead to water damage.
f Never close the drain pipe.
2.3
Test symbols
See type plate on the appliance.
4
| SHC 10 | SHC 15
3.
Appliance description
The appliance constantly keeps the water content available at the
preselected temperature. The appliance switches on automatically
as soon as its temperature falls below the set value.
Subject to season, varying cold water temperatures can result in
different maximum mixed water and outlet volumes.
Note
A qualified contractor can set a temperature limit on the
appliance (see "Installation / Settings / Setting the tem-
perature limit").
Note
The appliance is under mains water pressure. The water
volume increases as the cylinder is being heated up. Dur-
ing this process, expansion water drips through the safety
valve. This is a necessary and normal process.
3.1
Settings
You can set any required DHW outlet temperature at the tem-
perature selector. The heat-up indicator illuminates during the
heat-up process.
1
Temperature selector
2
Heat-up indicator
Depending on the system, the actual temperatures may vary from
the set value.
*
= Cold. On this setting, the appliance is protected from
frost. The tap, water lines and safety valve are not pro-
tected.
MAX = Highest selectable temperature
1
2
www.stiebel-eltron.com
Publicité
