Worx WX314 Mode D'emploi page 10

OPERATION INSTRuCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED uSE
The machine is intended for impact drilling in
brick, concrete and stone as well as for drilling
in wood, metal and plastic. Machines with
electronic control and right/left rotation are
also suitable for thread-cutting.
1. AuxILIARy hANDLE (See Fig. A)
Slide the handle onto the drill and rotate
to the desired working position. To clamp
the auxiliary handle rotates the handgrip
clockwise. To loosen the auxiliary handle rotate
the hand grip anti-clockwise. Always use the
auxiliary handle.
2. INSTALLINg ThE DEPTh gAugE
(See Fig. B)
The depth gauge can be used to set a constant
depth to drill. To use the depth gauge, loosen
the handle by rotating the bottom section of
handle anti-clockwise. Insert the depth gauge
10
through hole in handle. Slide the depth gauge
to required depth and tighten fully.
3. INSERTINg A TOOL INTO chucK
(See Fig. c1 ,c2)
To open the chuck jaws rotate the front section
of the chuck while holding the rear section.
Insert the drill bit between the chuck jaws
and rotate the front section in the opposite
direction while holding the rear section.
Ensure that the drill bit is in the center of
the chuck jaws. Finally, firmly rotate the two
separate chuck sections in opposite directions.
Your drill bit is now locked in the chuck.
4. ON/OFF SwITch
Depress the switch to start the tool and release
it to stop your tool.
5. SwITch LOcK-ON BuTTON
(See Fig. D)
Depress on/off switch then lock-on button,
release on/off switch first and lock-on button
second. Your switch is now locked on for
continuous use. To switch off your tool just
Impact drill
All manuals and user guides at all-guides.com
depress and release the on/off switch .
6. VARIABLE SPEED cONTROL
(See Fig. E )
Adjust the variable speed control to increase
or decrease the speed according to the
material and accessory to be used (also
possible during no load operation). Low speed
will provide low torque and high speed gives
higher torque.
7. FORwARD AND REVERSE ROTATION
cONTROL (See Fig. F )
For drilling use forward rotation marked " L
" (lever is moved to the left). Only use reverse
rotation marked " R " (lever is moved to the
right) to release a jammed drill bit.
operation or the on/off switch is locked
as this will damage the drill.
8. hAMMER OR DRILLINg cONTROL
(See Fig. g )
When drilling masonry and concrete choose
the hammer position "
wood, metal, plastic, choose the drill position.
"
WORKING HINTS FOR yOuR
DRILL
1. Drilling masonry and concrete
Select the drill/impact action selector switch
to the "hammer symbol" position. Tungsten
carbide drill bits should always be used for
drilling masonry, concrete etc with a high speed.
2. Drilling steel
Select the drill/impact action selector switch
to the "drill symbol" position. HSS drill bits
should always be used for drilling steel with a
lower speed.
3. Pilot holes
When drilling a large hole in tough material
(i.e. steel) , we recommend drilling a small
pilot hole first before using a large drill bit.
4. Drilling tiles
Select the drill/impact action selector switch
to the "drill symbol" position to drill the tile.
NOTE: Never move the forward/
reverse switch whilst the drill in
" . When drilling in
" .
EN