Pneumatic Components - Festo 8129208 Notice D'utilisation

5.3 Pneumatic components

•
Depressurize the system!
–
–
–
•
Risk of injury when switching on compressed air!
Cylinders may advance and retract automatically.
•
Risk of accident due to advancing cylinders!
–
–
•
Risk of accident due to pneumatic tubing slipping off!
–
–
•
Do not exceed the maximum permissible pressure of 1000 kPa (10 bar).
•
Do not switch on the compressed air until all the tubing connectors have been
joined and secured.
•
Do not disconnect tubing while under pressure.
–
© Festo Didactic 8130877
Switch off the compressed air supply before working on the circuit.
Check the system with pressure gauges to make sure that the entire circuit is
fully depressurized.
Please note that energy may be stored in reservoirs. Further information on
this issue is available in the datasheets and operating instructions included
with the components.
Always position pneumatic cylinders so that the piston rod's working space is
unobstructed over the entire stroke range.
Make sure that the piston rod cannot collide with any of the rigid components
in the setup.
Use shortest possible barbed tubing connections.
If pneumatic tubing slips off, switch off the compressed air supply
immediately.
Do not attempt to seal or plug pneumatic tubing or plug connectors with your
hands or fingers.
Single-Phase Energy Measurement Box – Operating Instructions
WARNING
15