Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Single Standard Installation
REFRIGERATOR/FREEZER LOCATION
Do not install the refrigerator/freezer where the temperature
will go below 55°F (13°C). It will not run often enough to
maintain proper temperatures.
Do not install the refrigerator/freezer where temperatures
will go above 100°F (37°C). It will not perform properly.
Do not install the refrigerator/freezer in a location exposed
to water (rain, etc.) or direct sunlight.
Install it on a floor strong enough to support it fully loaded.
TOOLS AND MATERIALS REQUIRED
• Metal shears (recommended)
• #1, #2 Phillips screwdriver
• Flathead screwdriver
• Putty knife (recommended)
• Measuring tape
• Drill and 1/16", 5/64", 3/16", 1/2" bits
• 5/32" concrete bit (if installing anti-tip into concrete)
• 1/4", 3/8", 7/16" driver/socket
• 7/16" open wrench
• T10, T20, T30 driver/bit
• 1/8", 1/4" hex driver (allen wrench)
• Level
• Water shut-off valves (optional but recommended)
• 8' waterline
• Masking tape
• Rubbing alcohol
• 10" Adjustable wrench
• Center punch
• Stainless Steel Door Kit (if applicable)
• Custom panels for doors (if applicable)
• Handle Kit (if applicable)
• Small Rachet 1/4" or 3/8"
• Standard Trim Kit (ZKW36V)
• 90° Right Angle Driver or a minimum 8" long, 1/4" diameter
bit extender
HARDWARE SUPPLIED (per unit)
• Anti-Tip bracket (2)
• Lag screws
• Tapcon screws
• 1/4" Hex Screws
• Door Hardware Kit
31-1000731 Rev. 1
GROUNDING THE UNIT
WARNING
Hazard.
Failure to follow these instructions can result
in death, fire, or electrical shock.
AVERTISSEMENT
Le non-respect de ces instructions peut occasionner un
décès, un incendie ou un choc électrique
ADVERTENCIA
Si no se siguen estas instrucciones, se podrá producir
la muerte, incendios o descargas eléctricas.
The power cord of this appliance is equipped with a 3-prong
(grounding) plug which mates with a standard 3-prong
(grounding) wall receptacle to minimize the possibility of elec-
tric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
Where a standard 2-prong wall outlet is encountered, it is
your personal responsibility and obligation to have it replaced
with a properly grounded 3-prong wall outlet.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT
OR REMOVE THE THIRD (GROUND) PRONG
FROM THE POWER CORD.
DO NOT USE AN ADAPTER PLUG TO
CONNECT THE REFRIGERATOR TO A
2-PRONG OUTLET.
DO NOT USE AN EXTENSION CORD WITH
THIS APPLIANCE.
FLOORING
For proper installation, this product must be placed on a level
surface of hard material that is at the same height as the rest of
the flooring. This surface should be strong enough to support a
fully loaded refrigerator or freezer, or approximately 1,200 lbs.
per unit.
NOTE: Protect the finish of the flooring.
NOTE: Not recommended for installation on carpeted flooring.
9
Electrical Shock
Risque d'électrocution
Riesgo de Descarga
Publicité
