Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - Dual Integrated Installation
STEP 9 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
Open both enclosure doors to 90°.
Snap the trim bracket between the water filter access
enclosures above displays.
If installation requires a
limiter pin(s) must be installed
- Open the door to expose the hole in the back hinge
bracket and install the limiting pin. Pin must be
fully seated in the hinge or the door will not close
properly.
90°
door opening, the hinge
in the top
hinge(s).
STEP 10 HANDLE INSTALLATION
Make sure the set screws in the handle caps are
loosened. Place the handle over the fasteners on
the door (we recommend putting the screw side of
the handle toward the less visible side). Take care to
support the handle so it doesn't fall and scratch the
appliance finish. Make sure both of the handle caps
are resting on the face of the door.
Fastener
Lock one end of the handle into position by tightening
the set screw in the handle cap with the 1/8" Allen
wrench. Be sure not to over tighten.
Keep supporting the handle as you lock the other
end of the handle into position by tightening the set
screw in the handle cap with the 1/8" Allen wrench.
Be sure not to over tighten.
Repeat these instructions on all other handles.
STEP 11 TOE KICK INSTALLATION
A stainless steel toe kick and a magnet are included
with each refrigerator. A full width toe kick (ZKN72V)
for dual integrated installations can be purchased
separately.
Remove the toe kick magnets from the front access
covers. These will only be used if installing the
individual toe kicks.
For individual toe kicks, adhere magnets to the back
side of the toe kicks. The surface of the toe kick
where the magnet is to be placed must be clean and
free of foreign material. Center magnets vertically
and horizontally.
Position toe kick(s) on bottom portion of front access
covers.
56
Set Screw
31-1000731 Rev. 1
Publicité
