EINHELL CE-AP 18 Li Mode D'emploi page 11

6.3 Infl ating (Fig. 4/5)
Use the enclosed nozzles if necessary.
•
Plug the large nozzle (Item 3) onto the
inflation connector (Item 2) and turn it to the
left until it locks in place.
•
Press the small nozzle (Item 4) onto the
already mounted large nozzle if needed.
6.4 Defl ating (Fig. 6)
Use one or, if necessary, use both of the enclosed
nozzles as shown.
Note:
To avoid problems during infl ation or defl ation,
make sure when you insert the small nozzle into
standard valves that the usually existing non-
return valve (valve fl ap) is open. This can be
opened slightly by gently squeezing the valve
together.
6.5 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.6 Battery capacity indicator (Fig. 7 / item 9)
Press the battery capacity indicator switch (10).
The battery capacity indicator (9) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
Anl_CE_AP_18_Li_SPK7_USA.indb 11 Anl_CE_AP_18_Li_SPK7_USA.indb 11
EN
7. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
8. Faults
The equipment does not work:
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to a service center.
- 11 -
31.05.2023 10:49:24 31.05.2023 10:49:24