EINHELL CE-AP 18 Li Mode D'emploi page 10

3. Intended use
This machine is designed exclusively for infl ating
high-volume items such as rubber dinghies and
large air mattresses. It is not suitable for vehicle
tires, bicycle tires and infl atable low-volume
leisure, sports and beach articles.
The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or
injuries of any kind resulting from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be voided
if the equipment is used in commercial, trade or
industrial businesses or for equivalent purposes.
4. Technical data
Motor power supply: ............................ 18V
No load RPM:............................................ 18,700
Max. air pressure:....................................0.76 PSI
Max. air fl ow: .......................................23.66 CFM
Weight (Tool only): ...................................1.32 lbs
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's con-struction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
Anl_CE_AP_18_Li_SPK7_USA.indb 10 Anl_CE_AP_18_Li_SPK7_USA.indb 10
EN
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
5. Before starting the equipment
5.1 Fitting a battery (Fig. 3)
Push the battery into the battery mount provided.
When the battery is positioned as in Fig. 3, make
sure that the pushlock button (8) latches in place!
6. Operation
Warning!
•
The equipment does not have an automatic
cut-out. You must therefore monitor the com-
plete inflation and deflation process.
•
Do not exceed the inflation pressure
recommended by the manufacturer in any
circumstances. If inflated objects burst, they
can cause serious injuries.
•
Never insert any objects in the deflation
connector or the inflation connector. Do not
cover the air openings.
•
Never direct the air outlet towards eyes while
the equipment is working.
•
To prevent overheating, allow the equipment
to cool down after every 20 minutes of opera-
tion.
•
In the event of overloading, switch off the
equipment immediately and allow it to cool.
6.1 Switching on and off (Fig. 1)
•
To activate the equipment briefly, press and
hold the switch (Item 5) lightly.
•
Press the switch (Item 5) to switch on the
equipment. The switch will latch in place and
does not need to be held.
•
To switch off, press the switch (Item 5) again.
6.2 LED light (Fig. 1)
The LED lamp (Item 6) can illuminate the work
area in poor lighting conditions. It lights up
automatically when the equipment is switched on,
and it continues to shine for a few seconds when
the equipment is switched off .
- 10 -
31.05.2023 10:49:24 31.05.2023 10:49:24