Worx HandyCut WX424 Traduction Des Instructions Initiales page 13

into the beam, please observe all safety
rules as follows:
1. The laser shall be used and maintained
in accordance with the manufacturer's
instructions.
2. Never aim the beam at any person or
an object other than the work piece.
3. The laser beam shall not be
deliberately aimed at another person
and shall be prevented from being
directed towards the eye of a person
for longer than 0.25 seconds.
4. Always ensure the laser beam is
aimed at a sturdy work piece without
reflective surfaces, e.g wood or rough
coated surfaces are acceptable. Bright
shiny reflective sheet steel or similar is
not suitable for laser applications as the
reflective surface may direct the laser beam
back at the operator.
5. Do not change the laser device with
a different type. Repairs must be carried
out by the manufacturer or an authorized
agent.
6. cAUTION: Use of controls or
adjustments other than those
specified herein may result in
hazardous radiation exposure.
Additional safety warning for class 2
laser
The laser device fitted to this tool is
class 2 with a maximum radiation of
1mw and 650nm wavelength.
cLASS 2 LASER RADIATION, DO NOT
STARE INTO bEAM
Mini multi-function saw
All manuals and user guides at all-guides.com
SYMBOLS
WARNING-To reduce the risk of
injury, user must read instruction
manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
local authority or retailer for
recycling advice.
Laser radiation
Do not stare into beam
13 13
EN