Makita 9564PC Manuel D'instruction page 8

Installing or removing depressed
center grinding wheel/Multi-disc
(accessory)
Mount the inner flange onto the spindle. Fit the wheel/disc
on the inner flange and screw the lock nut onto the spindle.
1
2
3
► 1. Lock nut 2. Depressed center grinding wheel/
Multi-disc 3. Inner flange
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise. To remove the
wheel, follow the installation procedure in reverse.
1
2
► 1. Lock nut wrench 2. Shaft lock
Installing or removing flex wheel
(optional accessory)
1
2
3
4
► 1. Lock nut 2. Flex wheel 3. Back up pad 4. Inner
flange
WARNING:
• Always use supplied guard when flex wheel is
on tool. Wheel can scatter during use and guard
helps to reduce chances of personal injury.
Follow instructions for depressed center grinding wheel/
Multi-disc but also use back up pad over wheel. See
order of assembly on accessories page in this manual.
Installing or removing abrasive disc
(optional accessory)
► 1. Lock nut 2. Abrasive disc 3. Rubber pad
NOTE:
• Use sander accessories specified in this man-
ual. These must be purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
OPERATION
WARNING:
• It should never be necessary to force the tool.
The weight of the tool applies adequate pres-
sure. Forcing and excessive pressure could
cause dangerous wheel breakage.
• ALWAYS replace wheel if tool is dropped while grinding.
• NEVER bang or hit grinding disc or wheel onto work.
• Avoid bouncing and snagging the wheel, espe-
cially when working corners, sharp edges etc.
This can cause loss of control and kickback.
• NEVER use tool with wood cutting blades and
other sawblades. Such blades when used on a
grinder frequently kick and cause loss of control
leading to personal injury.
CAUTION:
• After operation, always switch off the tool and
wait until the wheel has come to a complete stop
before putting the tool down.
8 ENGLISH
1
2
3