Makita 9564PC Manuel D'instruction page 7

Electronic function
Constant speed control
• Possible to get fine finish, because the rotating
speed is kept constantly even under the loaded
condition.
• Additionally, when the load on the tool exceeds
admissible levels, power to the motor is reduced
to protect the motor from overheating. When the
load returns to admissible levels, the tool will
operate as normal.
Soft start feature
• Soft start because of suppressed starting shock.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
CAUTION:
• The wheel guard must be fitted on the tool so
that the closed side of the guard always points
toward the operator.
• When using a depressed center grinding wheel/
Multi-disc, flex wheel, wire wheel brush, cut-off
wheel or diamond wheel, the wheel guard must
be fitted on the tool so that the closed side of the
guard always points toward the operator.
For tool with locking screw type wheel guard
1
2
► 1. Wheel guard 2. Bearing box 3. Screw
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees coun-
terclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
For tool with clamp lever type wheel guard
1
2
► 1. Wheel guard 2. Bearing box 3. Screw 4. Lever
1
► 1. Screw
Pull the lever in the direction of the arrow after loosening the
screw. Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box. Then rotate
the wheel guard around 180°. Fasten it with the screw after pull-
ing lever in the direction of the arrow for the working purpose. The
setting angle of the wheel guard can be adjusted with the lever.
To remove wheel guard, follow the installation procedure in reverse.
7 ENGLISH
3
3
4