Optional Accessories - Makita 9564PC Manuel D'instruction

Operation with wire cup brush
(optional accessory)
► 1. Wire cup brush
CAUTION:
• Check operation of brush by running tool with no load,
insuring that no one is in front of or in line with brush.
• Do not use brush that is damaged, or which is out of
balance. Use of damaged brush could increase poten-
tial for injury from contact with broken brush wires.
Unplug tool and place it upside down allowing easy access to
spindle. Remove any accessories on spindle. Thread wire cup
brush onto spindle and tighten with supplied wrench. When
using brush, avoid applying too much pressure which causes
over bending of wires, leading to premature breakage.
Operation with wire wheel brush
(optional accessory)
► 1. Wire wheel brush
CAUTION:
• Check operation of wire wheel brush by running
tool with no load, insuring that no one is in front
of or in line with the wire wheel brush.
• Do not use wire wheel brush that is damaged, or which is
out of balance. Use of damaged wire wheel brush could
increase potential for injury from contact with broken wires.
• ALWAYS use guard with wire wheel brushes,
assuring diameter of wheel fits inside guard.
Wheel can scatter during use and guard helps
to reduce chances of personal injury.
1
1
10 ENGLISH
Unplug tool and place it upside down allowing easy access
to spindle. Remove any accessories on spindle. Thread wire
wheel brush onto spindle and tighten with the wrenches.
When using wire wheel brush, avoid applying too much pressure
which causes over bending of wires, leading to premature breakage.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
1
► 1. Exhaust vent 2. Inhalation vent
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
To maintain product SAFETY and RELIABILITY, repairs, car-
bon brush inspection and replacement, any other maintenance
or adjustment should be performed by Makita Authorized
Service Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified in this
manual. The use of any other accessories or attach-
ments might present a risk of injury to persons. Only
use accessory or attachment for its stated purpose.
• Your tool is supplied with a guard for use with
any recommended grinding wheel, multi-disc,
flex wheel and wire wheel brush. If a diamond
wheel and/or cut-off wheel are also available for
use with the tool, they should only be used with
the appropriate optional guard for cut-off wheels.
If you decide to use your Makita grinder with
approved accessories which you purchase from your
Makita distributor or factory service center, be sure
to obtain and use all necessary fasteners and guards
as recommended in this manual.Your failure to do so
could result in personal injury to you and others.
2