Télécharger Imprimer la page

Philips AT621 Mode D'emploi page 2

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Introduction
Congratulations on your purchase and welcome to Philips! To fully
benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
Please read this user manual, as it contains information about the
features of this shaver as well as some tips to make shaving easier and
more enjoyable.
General description (Fig.1)
1 Shaving unit
2 On/off button
3 Charging light
4 Socket for small plug
5 Small plug
6 Supply unit (adapter, type HQ850)
7 Trimmer release slide (AT621, AT620 only)
8 Trimmer (AT621, AT620 only)
9 Guard
10 Cutter
11 Retaining frame
Note: You can find the type number on the back of the shaver.
Important safety information
Read this important information carefully before you use the appliance
and its accessories and save it for future reference. The accessories
supplied may vary for different products.
Danger
-
Keep the supply unit dry (Fig. 2).
Warning
-
The supply unit contains a transformer. Do not cut off the supply
unit to replace it with another plug, as this causes a hazardous
situation.
-
Only charge the appliance with the supply unit provided.
-
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
-
Children should be supervised to ensure that they do not play with
the appliance.
-
Always unplug the shaver before you clean it under the tap.
-
Always check the appliance before you use it. Do not use the
appliance if it is damaged, as this may cause injury. Always replace
a damaged part with one of the original type.
-
Do not open the appliance to replace the rechargeable battery.
Caution
-
Never immerse the cleaning system or the charging stand in water
and do not rinse it under the tap (Fig. 2).
-
Never use water hotter than 80°C to rinse the shaver.
-
Only use this appliance for its intended purpose as shown in the
user manual.
-
For hygienic reasons, the appliance should only be used by one person.
-
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
-
If your shaver comes with a cleaning system, always use the original
Philips cleaning fluid (cartridge or bottle, depending on the type of
cleaning system).
-
Always place the cleaning system on a stable, level and horizontal
surface to prevent leakage.
-
If your cleaning system uses a cleaning cartridge, always make sure
the cartridge compartment is closed before you use the cleaning
system to clean or charge the shaver.
-
When the cleaning system is ready for use, do not move it to
prevent leakage of cleaning fluid.
-
Water may drip from the socket at the bottom of the shaver
when you rinse it. This is normal and not dangerous because all
electronics are enclosed in a sealed power unit inside the shaver.
-
Do not use the supply unit in or near wall sockets that contain or
have contained an electric air freshener to prevent irreparable
damage to the supply unit.
All manuals and user guides at all-guides.com
Electromagnetic fields (EMF)
-
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
General
-
This shaver is waterproof (Fig. 3). It is suitable for use in the bath
or shower and for cleaning under the tap. For safety reasons,
the shaver can therefore only be used without cord.
-
The appliance is suitable for mains voltages ranging from 100 to
240 volts.
-
The supply unit transforms 100-240 volts to a safe low voltage
of less than 24 volts.
Charging
Note: The appliance cannot be used directly from the power outlet.
When you charge the shaver for the first time or after a long period of
disuse, let it charge for at least 10 hours.
A fully charged shaver provides up to 30 minutes of shaving time.
The shaving time may be less than expected as a result of your shaving
behaviour, your cleaning habits or your beard type.
Charging with the adapter
1 Put the small plug in the shaver.
2 Put the adapter in the wall socket.
Charge indications
Battery low
When the battery is almost empty (when there are only 5 or fewer
shaving minutes left), the charging light lights up orange (Fig. 4).
-
When you switch off the shaver, the charging light continues to light
up orange for a few seconds.
Charging
When the shaver is charging, the charging light lights up green
continuously (Fig. 4).
-
The charging light will keep lighting up green when the shaver is
fully charged.
Using the appliance
Note: This appliance can only be used without cord.
Switching the appliance on and off
1 To switch on the appliance, press the on/off button once (Fig. 5).
2 To switch off the appliance, press the on/off button once.
Shaving tips
-
This shaver is suitable for both wet and dry use. Use the shaver with
shaving gel or foam for extra skin comfort, or use the shaver dry for
extra convenience.
-
We advise you to use the shaver with shaving gel or foam when you
use it for a wet shave. Do not use thick shaving cream or shaving oil
with this shaver.
-
When you use the shaver for dry shaving, we advise you to make sure
your skin is fully dry so that the shaver glides smoothly over your skin.
-
For optimal shaving results, make circular movements during use.
-
The shaver is waterproof and can be used in the bath or shower.
-
Your skin may need 2 to 3 weeks to get accustomed to the Philips
shaving system.
Wet shaving
You can also use this shaver on a wet face with shaving foam or
shaving gel.
To shave with shaving foam or shaving gel, follow the steps below:
1 Apply some water to your skin (Fig. 7).
2 Apply shaving foam or shaving gel to to your skin (Fig. 8).
3 Rinse the shaving unit under the tap to ensure that the shaving unit
glides smoothly over your skin.
4 Switch on the appliance.
5 Move the shaving heads over your skin in circular movements.
Note: Rinse the shaving unit regularly to ensure that it continues to
glide smoothly over your skin (Fig. 9).
6 Dry your face.
7 Clean the shaver after use.
Note: Make sure you rinse all foam or shaving gel off the shaver.

Publicité

loading

Ce manuel est également adapté pour:

At620At610