Setting The Clock; Disc - Playback; Loading A Disc; Playing A Disc - Sony GENEZI MHC-GNX660 Mode D'emploi

Setting the clock

Use buttons on the remote for the operation.
1
Press ?/1 to turn on the system.
2
Press CLOCK/TIMER SET.
"CLOCK" appears in the display. Then, the
hour indication flashes in the display.
3
Press –. or >+ repeatedly to set
the hour.
4
Press ENTER.
The minute indication flashes in the
display.
5
Press –. or >+ repeatedly to set
the minute.
6
Press ENTER.
The clock starts functioning.
To adjust the clock
1
Press CLOCK/TIMER SET.
"SET" appears in the display, then "PLAY
SET" flashes in the display.
2
Press –. or >+ repeatedly to select
"CLOCK SET", then press ENTER.
The hour indication flashes in the display.
3
Do the same procedures as step 3 to 6
above.
Notes
• The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
• You cannot set the clock in Power Saving Mode
(page 23).
Disc – Playback

Loading a disc

1
Press Z OPEN/CLOSE.
The disc tray slides out.
2
Load a disc with the label side facing
up on the disc tray.
When you
play back a 8
cm disc such
as CD single,
place it on the
inner circle of
the tray
To load additional discs, press
DISC SKIP/EX-CHANGE to rotate the
disc tray.
3
Press Z OPEN/CLOSE to close the disc
tray.
Notes
• Do not push the disc tray when closing it as this may
cause malfunction. Press
the disc tray.
• Do not use a disc with cellophane tape, seals or paste
on it as this may cause malfunction.

Playing a disc

— Normal Play/Shuffle Play
This system lets you play back CDGs*, AUDIO
CDs and discs with MP3 audio tracks in
different play modes.
Before playing a CDG*, turn on your TV and
select the video input.
* MHC-GNX660 only
OPEN/CLOSE to close
Z
continued
9 GB