Functional Description; Safety System - Makita LXTP01 Manuel D'instruction

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
011981
Always switch off the tool before installing or
•
removing of the battery cartridge.
To remove the battery cartridge, slide it from the tool
•
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can see
the red indicator on the upper side of the button, it is
not locked completely. Install it fully until the red
indicator cannot be seen. If not, it may accidentally
fall out of the tool, causing injury to you or someone
around you.
Do not use force when installing the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.

Safety system

WARNING:
Make sure all safety systems are in working order
•
before operation. Failure to do so may cause
personal injuries.
1
007726
Test safety systems for possible faulty operation before
pin-nailing as follows.
1. Make sure that the tool is not loaded with pin nails
before the test.
1. Red indicator
2. Button
3. Battery cartridge
3
1. Trigger
2. Lever
2
2. Pull the sliding door of the magazine toward
yourself.
011938
3. The tool accidentally operates if only the trigger is
pulled although the lever is not pulled.
4. The tool does not operate when the trigger is
pulled with the lever pulled.
In case of 3 and 4 above, the safety systems are faulty.
Trigger and lever
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
007728
The tool is provided with lever as a safety system in
addition to the usual trigger.
007729
To fire pin-nails, first pull the lever and then pull the
trigger.
Adjusting the depth of pin-nailing
WARNING:
Always make sure that your fingers are not placed
•
on the trigger or the lever and the battery cartridge
is removed before loading the pin nailer.
5
1. Sliding door
1
1. Lever
1
1. Trigger
1