EINHELL AXXIO 36/230 Q Mode D'emploi page 15

5. Before starting the equipment
Warning!
Always remove the battery before making
adjustments to the equipment.
5.1 Fitting the additional handle (Fig. 2)
•
The angle grinder must not be used without
the additional handle (3).
•
The additional handle can be secured in any
of three positions (A, B, C).
Tool side
Left (position A / as
shown)
Right (position B)
Top (position C)
5.2 Replacing and adjusting the guard (Fig. 3)
Replacing:
•
Remove the flange nut (7) and the clamping
flange (6) underneath.
•
Open the clamp lever (9) on the guard (4).
•
Turn the guard (4) 180° in clockwise direction
so that the guard points upwards.
•
Remove the guard (4).
To mount, proceed in the reverse order.
Adjusting:
•
Adjust the guard (4) to protect your hands
so that the material being ground is directed
away from your body.
•
The position of the guard (4) can be adjusted
to any specific working conditions. Undo the
clamp lever (9) and turn the cover (4) into the
required position.
•
Ensure that the guard (4) correctly covers the
gear wheel casing.
•
Secure the clamp handle (9) again.
•
Ensure that the guard (4) is secure.
Make sure that the guard is perfectly
secure.
Never use the angle grinder without the
guard.
Trial run for new grinding wheels
Have the angle grinder run in idle mode for at
least 1 minute with the grinding or cutting wheel
Anl_Axxio_36_230_Q_SPK7_USA.indb 15 Anl_Axxio_36_230_Q_SPK7_USA.indb 15
EN
Suitable for
Right-handed users
Left-handed users
Using cut-off wheels
- 15 -
fi tted. Replace vibrating wheels immediately.
5.3 Swivel handle (Fig. 4)
The handle can be swiveled a maximum of 90°
to the left and right. To do so, press the locking
button (11) and swivel the handle 90° to the left or
right. When the locking button (11) engages
correctly it makes an audible click.
6. Operation
6.1 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.2 On/Off switch (Fig. 5)
The angle grinder comes with a safety switch
which is designed to prevent accidents. To start
the equipment, push the lock lever (12) forward,
then press the On/Off switch (2).
Important!
Following a stoppage (due to overloading),
the cordless equipment will start up again
automatically.
Wait until the machine has reached its
top speed. You can then position the angle
grinder on the workpiece and machine it.
6.3 Battery capacity indicator (Fig. 6 / item
14)
Press the battery capacity indicator switch (13).
The battery capacity indicator (14) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depth-discharged and is defective. Remove the
battery from the device. Never use or charge a
14.07.2023 09:24:36 14.07.2023 09:24:36