Campingaz CAMPING KITCHEN 2 GRILL & GO CV Mode D'emploi page 10

Avoid twisting the flexible hose.
When the appliance is in operation, the support on which
the unit is standing can get very hot. The unit must not
be placed on a combustible surface (plastic, tablecloth,
etc.). It is recommended that the unit be placed on a
heat-resistant surface (concrete, stone, brick, directly
on the ground (earth)). Otherwise, an incombustible,
heat-insulating material should be placed between the
unit and its support.
Never leave the cooking plate on fire without foodstuffs
longer than one minute (except for the initial pre-heating
period) otherwise the special coating will be damaged.
To avoid damaging the non-stick coating, always use
cooking utensils in silicone or wood to manipulate your
dishes.
1) Lighting up
- Open the gas supply (valve or lever on regulator).
- Rotate the knob corresponding to the burner anti-clockwise to
the maximum flow rate position (
- Wait 2 to 3 seconds and press the corresponding piezoelectric
button ( ) several times until the burner lights (Fig. 4A). If it
does not light after 3 tries, position the adjusting knob to
•
"OFF" ( ) by rotating it clockwise. Wait 1 minute before
repeating the operation.
- The stove can be ignited by holding a flame close to the
burner (Fig. 4B).
2) Cooking
The appliance can be used as a stove or be fully converted as
a grill thanks to the provided griddles (4). Depending on your
cooking needs, you can mix the configurations by using one
burner as a grill and the other one as a stove.
a) Using the appliance as a grill
- Make sure the pan supports (2) are well installed on the stove
(Fig. 6).
- Position the griddle above the burner, it must stand on the pan
support as explained in Fig. 3 and Fig. 10.
- Pre-heat the griddle for around 5 minutes at maximum power
in order to reach the ideal temperature for cooking. Place your
ingredients on the plate and adjust the temperature with the
control knob according to your tastes.
The cooking plate is covered with a high quality non-sticking
material which ensures healthy cuisine without adding fat or oil.
A bluish discolouration of the cooking plate is due to the strong
heat development. This is without any impact on the quality of
the used material.
b) Using the appliance as a stove
IMPORTANT: Griddles must be taken away when using the
appliance as a stove. Never place cooking vessels on the
griddles. Never use the equipment without the pan support.
Place a cooking vessel (frying pan, pan...) on the pan support,
centered over the burner. Ensure that the flame does not
exceed the underside of the cooking vessel.
Do not use a cooking vessel smaller than 12 cm or larger than
24 cm in diameter.
3) Shutting down
- After use, close the stove valve by putting the knob in "OFF"
•
position ( ). Fig. 1.
D - REMOVING OR CHANGING THE CAMPINGAZ
CV 470 PLUS CARTRIDGE
The cartridge may be removed even if it is not empty. Replace
the cartridge outside and away from other people.
- Wait for the stove to cool down.
- Check that the valves on stove are fully turned off by turning
the control knobs (1) clockwise to its full extent.
- Detach the regulator (3) from the cartridge by unscrewing the
regulator (3), then lift it up (Fig. 5B).
).
®
- Push the regulator (3) onto a new cartridge and screw it tight
until you hear a click (approximately one-sixth of a turn) (Fig.
5A). Do not force the cartridge to turn further than this or you
may risk damaging the Easy Clic
E - MAINTENANCE & STORAGE
In case of burn back (ignition under the burner cap) switch the
product off, allow it to cool down (approximately five minutes),
then reignite the appliance. If the problem of burn back persists,
then please contact your local Campingaz
1) Stove
Ensure that your stove is regularly maintained, and it will give
you many years of excellent service.
- Do not clean the stove while it is in operation. Wait for it to
cool down, to avoid burning yourself on the hot parts (pan
supports, burners).
- When cleaning, be careful to avoid clogging the burner holes.
If the holes are clogged, for example by food that has spilled
over, clear them with a non-metal brush.
- Clean greasy parts with soap and water or a non-abrasive
detergent.
- Warning: Do not clean the griddles in a dishwasher.
- The pan supports (2) can be removed for cleaning purposes
by pulling them upwards.
- To reattach the pan supports, insert the legs into the holes on
each side of the burners (Fig. 2)
- Store the equipment and the cartridge in a cool, dry and
well-ventilated area, out of reach of children. Never store in a
basement or cellar.
- If the stove has not been in use for more than 30 days,check
to see if cobwebs or anything else is not clogging the burner
tube openings; this could lead to decreased burner efficiency
or to a dangerous ignition of gas outside the burner.
- Store your appliance in the carry bag (5). Open the bag and
unfold the straps (Fig. 11A). Put the griddles upside down
inside the carry bag (Fig. 11B). Install the stove above the
griddles then tight the straps (Fig. 11C). Close the bag, your
appliance can be easily carried and is stored away from dust
(Fig. 11D).
2) Hose connecting the regulator and the stove
- Regularly check the condition of the hose and change it if it
shows signs of wear or cracking. Please contact your local
after sales service (see separate sheet with contact details
included in the package).
- If the stove will not be used for a long period of time
disconnect the cartridge as indicated in paragraph D.
- The date which is printed on the hose is the production date
and not the expiration date. The hose can be used without
time limit as long as it is not damaged.
In case of the injector becoming clogged (the equipment will
not light although the cartridge still contains gas), do not try to
unclog it yourself. Return the equipment to your retailer.
9
Plus System.
®
representative.
®
GB