Publicité
Les langues disponibles
Les langues disponibles
EN
Resetting the Check Filter
Indicator
Reset the Check Filter Indicator when:
lights up.
A.
Replace the filter (see page 13).
1.
Turn on the air purifier.
2.
Press and hold
for 3 seconds.
3.
4.
will turn off when successfully
reset.
B.
The filter was changed before
lit up.
1.
Press and hold
for 3 seconds.
This will turn on
.
Press and hold
again for 3
2.
seconds.
3.
will turn off when successfully
reset.
12
All manuals and user guides at all-guides.com
Cleaning the Filter
The Pre-Filter should be cleaned once a
month to increase the efficiency and extend
the life of your filter.
1.
Remove the filter from the housing and
peel the Pre-Filter away from the True
HEPA and Activated Carbon Filters.
[Figure
2.1]
2.
Clean both sides of the Pre-Filter using
a soft brush or vacuum hose to remove
hair, dust, and large particles.
3.
Gently wash the Pre-Filter under running
water. Dry completely before placing it
back on the velcro tape.
4.
Replace filter in housing.
Note: Do not clean the True HEPA and
Activated Carbon Filters.
When to
When to
Filter
Clean
Replace
Every 2–4
Pre-Filter
weeks
True HEPA
6–8 months
& Activated
Do not
Carbon
clean
Filter
Figure 2.1
CARE & MAINTENANCE (CONT.)
Replacing the Filter
1.
Unplug the air purifier and remove the
filter cover.
2.
Remove the old filter and properly
dispose of it.
3.
Clean out any remaining dust or hair
inside the air purifier using a vacuum
hose.
Do not
use water or liquids to
clean the air purifier.
[Figure
3.1]
4.
Unwrap the new filter and place
inside the air purifier with the pull tabs
facing out.
5.
Replace the filter cover. The air purifier
will not power on unless the filter cover
is replaced correctly.
6.
Reset the Check Filter Indicator (see
page 12).
Figure 3.1
Storage
If not using the air purifier for an extended
period of time, wrap the filter in plastic
packaging and store in a dry place to avoid
moisture damage.
EN
13
Publicité
