Magmaweld SMART Serie Mode D'emploi page 33

SMART SERIES
3.8 Placing The Wire Spool And Wire Feeding Process
• Unscrew the screw of the wire transport system by turning it. Slide the welding wire roller onto the wire
carrier system shaft and re-tighten the screw.
b
a
• Pull and lower the pressure screw on the wire feed roller, which means bring the pressure rollers to idle position.
Figure 8 : Placement of Wire Spool
• Find and open the welding wire end from the wire spool and cut off the end with
If the end of the wire is missed, the wire can jump like a spring and damage you and others.
• Pass the wire through the wire entry slot without releasing the wire into the rollers and into the torch
through the rollers.
(2)
(1)
(3)
• Pull the pressure adjustment screws towards you and release the pressure on the rollers .
Figure 9 : Feeding the Wire to Rollers
• Turn the on/off switch to position "1" to start the machine .
• Remove the nozzle and the contact nozzle and press the trigger until the wire comes out from the tip of the
torch, while observing that the welding wire roller rotates freely then push and release the trigger a few
times to check for any loosening of the winding .
• Re-attach the nozzle and contact nozzle to the torch when the wire comes out from the tip of the torch .
• Drive the wire on a non-insulating material
adjustment and cut the tip of the wire
www.magmaweld.com
c
Tightening the screw of the wire transport system prevents the
wire from being fed and may cause failures. If the screw has not been
tightened adequately this can cause the wire spool to empty
after a period of time when the wire feed has stopped. For this
reason, do not connect the screw too tightly or too loosely.
a side chisel.
.
such as wood and make the appropriate wire pressure
BOARD
Operation 33
EN
USER MANUAL