Magmaweld SMART Serie Mode D'emploi page 22

22 Operation
OPERATION
EN
3.1 Settings in the Bag
As long as the button is pressed, the wire is driven and the gas valve does not work. You can use this button to
1-) WIRE FEEDING
drive the wire into the torch.
As long as the button is pressed, gas flow is ensured and wire feed does not work. You can use this button after
2-) GAS FLOW
gas change.
Welding method is selected. Each press of the button enables a transition between the lines in the relevant
3-) WELDING METHOD SELECTION
column. When the welding method is selected, the relevant led will light.
• MIG/MAG
Setting Range
• Pulse MIG/MAG
Pulse welding method is only available in models with pulse. In no pulse( W/O Pulse) models,
• MMA
when this line is reached, the led will not light and Pulse will not be active.
According to the welding method chosen you need to adjust your connections and accessories.
• Lift TIG
There is a separate outlet for the MMA method in front of the machine.
In Lift TIG welding method, suitable apparatus should be used for torch connector connection.
Thanks to the special apparatus, it will be compatible with the Euro connectore.
USER MANUAL
3 4
1 2
5 6
SMART SERIES
www.magmaweld.com