Magmaweld SMART Serie Mode D'emploi page 23

SMART SERIES
Wire type is selected. The type of wire to be used must be selected correctly. Each press of the button enables
4-) WIRE TYPE SELECTION
a transition between the lines in the relevant column. When the wire type is selected, the corresponding led
will light.
• Steel
Setting Range
• FCW
• FCW-M
• CrNi
Wire diameter is selected. The wire diameter to be used must be selected correctly. Each press of the button
5-) WIRE DIAMETER SELECTION
enables a transition between the lines in the relevant column. When the wire type is selected,
the corresponding led will light.
• 0.6 - 2.4 mm
Setting Range
Gas type is selected. The type of gas to be used must be selected correctly. Each press of the button enables
6-) GAS TYPE SELECTION
a transition between the lines in the relevant column. When the wire type is selected, the corresponding led
will light.
• CO2
Setting Range
• Ar/15-25 CO2
• Ar/10-15 CO2
www.magmaweld.com
• AlMg
• AlSi
• CuSi
• CuAl
• Ar/5-10 CO2
• Ar/2.5 C02
• Argon
Operation 23
EN
USER MANUAL