Magmaweld SMART Serie Mode D'emploi page 25

SMART SERIES
Welding mode is selected. Each press of the button enables a transition between the lines in the relevant
3-) WELDING MODE SELECTION
column. When the welding mode is selected, the relevant led will light.
• Classic Mode
Setting Range
• Smart Mode
• Synergic Mode
The choice you make from the method tab in the bag creates a differentiation in the welding mode options.
When MIG / MAG welding method is selected as the welding method, the modes are as follows:
When selected, you can adjust your wire speed and welding voltage in certain tolerance value ranges. Wire
CLASSIC MODE
speed will be adjusted between 1-24 m/min, welding voltage will be adjusted between 15-40 V.
When selected, welding parameters such as wire type, wire diameter, gas type must be selected correctly.
SMART MODE
The machine will automatically adjust the optimum voltage according to the selected welding current. You
can adjust the voltage by turning the adjustment knob in the +/- direction within a certain tolerance range.
When selected, welding parameters such as wire type, wire diameter, gas type and thickness must be
SYNERGIC MODE
selected correctly. Both the current and the voltage will be automatically adjusted according to the selected
welding parameters. The user can navigate both in the current and voltage within a certain tolerance range.
The machine will automatically recalculate the voltage according to the current value set at the specified
tolerance.
If you want to see which value the machine originally recommends and return to that value, simply press
When Pulse MIG / MAG) welding method is selected as the welding method, the modes are as follows:
the adjustment button once.
Pulse MIG/MAG welding method is only available in models with pulse.
When selected, you can adjust your wire speed and welding voltage in certain tolerance value ranges. Wire
CLASSIC MODE
speed will be adjusted between 1-24 m/min, welding voltage will be adjusted between 15-40 V.
When selected, welding parameters such as wire type, wire diameter, gas type must be selected correctly.
SMART MODE
The machine will automatically adjust the optimum voltage according to the selected welding current. You
can adjust the voltage by turning the adjustment knob in the +/- direction within a certain tolerance range.
When selected, welding parameters such as wire type, wire diameter, gas type and thickness must be
SYNERGIC MODE
selected correctly. Both the current and the voltage will be automatically adjusted according to the selected
welding parameters. The user can navigate both in the current and voltage within a certain tolerance range.
The machine will automatically recalculate the voltage according to the current value set at the specified
tolerance.
When MMA and Lift TIG welding are selected as welding methods, there is no selection in the mode section.
www.magmaweld.com
Operation 25
EN
USER MANUAL