Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-880-001.book Page 24 Tuesday, March 24, 2009 4:39 PM
24 | English
¢ Keep hands away from the cutting area
while the machine is running. Danger of in-
jury when coming in contact with the saw
blade.
¢ Never remove cutting remainders, wood
chips, etc. from the sawing area while the
machine is running. Always guide the tool
arm back to the neutral position first and
then switch the machine off.
¢ Guide the saw blade against the workpiece
only when the machine is switched on. Oth-
erwise there is damage of kickback, when
the saw blade becomes wedged in the work-
piece.
¢ Operate the power tool only when the work
area to the workpiece is clear of any adjust-
ing tools, wood chips, etc. Small pieces of
wood or other objects that come in contact
with the rotating saw blade can strike the op-
erator with high speed.
¢ Always firmly clamp the piece to be
worked. Do not saw workpieces that are too
small to clamp. Otherwise, the clearance of
your hand to the rotating saw blade is too
small.
¢ Operate the machine only for materials
mentioned under "Intended Use". Other-
wise, the machine can be subject to over-
load.
¢ If the saw blade should become jammed or
when interrupting work, switch the saw off
and hold the workpiece until the saw blade
comes to a complete stop. Never attempt to
remove the workpiece as long as the saw
blade is in motion, otherwise kickback may
occur. Determine and correct the cause for
the jamming of the saw blade.
¢ Do not use dull, cracked, bent or damaged
saw blades. Unsharpened or improperly set
saw blades produce narrow kerf causing ex-
cessive friction, blade binding and kickback.
1 609 929 S46 | (24.3.09)
¢ Always use saw blades with correct size
and shape (diamond versus round) of arbor
holes. Saw blades that do not match the
mounting hardware of the saw will run ec-
centrically, causing loss of control.
¢ Do not use high speed steel (HSS) saw
blades. Such saw blades can easily break.
¢ Do not touch the saw blade after working
before it has cooled. The saw blade be-
comes very hot while working.
¢ Never operate the machine without the in-
sert plate. Replace a defective insert plate.
Without flawless insert plates, injuries are
possible from the saw blade.
¢ Do not direct the laser beam at persons or
animals and do not stare into the laser
beam yourself, not even from a distance.
This power tool produces laser class 2 laser
radiation according to EN 60825-1. This can
lead to persons being blinded.
¢ Do not allow children unsupervised use of
the power tool with laser. They could blind
other people.
¢ Do not replace the installed laser with an-
other laser type. A laser that does not fit to
this power tool could pose dangers for other
persons.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Bosch Power Tools
Publicité
Table des Matières
