Tolerance Mode - Hexagon TT80 Mode D'emploi

6.6

Tolerance mode

Tol
Choose this mode to measure with value classification through contact relays on the
15-pin Sub-D connector and LEDS. This mode also allows the use of the output for 40
good classes.
In the standard mode, each classification output is disabled. This permits, for instance, the
measuring device currently used to be set on the TESATRONIC when taking measurements
with a programmable device connected to these outputs. No interaction will affect one
another. Once all settings or checks have been made, toggle to the tolerance mode.
Tol
Pressure 1
Displays the upper tolerance value
along with its position on the ana-
logue display.
Tol
Pressure 2
Displays the lower tolerance value
along with its position on the ana-
logue display (both values are
now visible on the display).
Tol
Pressure 3
Enables the measuring mode with
tolerances and value classifica-
tion.
Tol
Pressure 4
Returns to the standard mode.
14
Tolerances are set by pressing these keys
Doing so, the LEDs are off and the classifi-
cation relays on.