Publicité
Les langues disponibles
Les langues disponibles
5.
Align hood-mounting bracket to the two screws on the wall and hook hood into place.
Tighten screws to secure hood to the wall. CAUTION: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Duct Cover Installation
6.
Mark the position of the duct cover-mounting bracket. Use reference E from Table 2 and
measurements on page14. Attach and secure duct cover-mounting bracket with two
screws (not provided). Refer to Figure 9. NOTE: Inner duct cover will cover the duct
cover-mounting bracket.
Connect electrical wires. Refer to "Wiring to Power Supply." If necessary to hide the
7.
electrical wire connections, push wires back into the wiring box.
connections underneath the hood by removing the bottom casing. Before reattaching the
bottom casing, make sure wires do not slip between motors, impellers, or any moving
parts to prevent any damage. NOTE: Be careful when using electrical screwdriver,
damage to the hood may occur.
8.
Slide the inner duct cover up 2 inches before sliding entire duct cover onto the hood.
Refer to Figure 10.
9.
Adjust the height of the inner duct cover to the duct cover-mounting bracket. Secure
inner duct cover with two (4x8 mm) screws (provided) as shown in Figure 11.
All manuals and user guides at all-guides.com
Figure 7
Figure 9
10
Mounting
Screws
Figure 8
Access the wire
Figure 10
Publicité
