Télécharger Imprimer la page

Dometic EM12-150 Guide Rapide page 6

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
have been given supervision or instruction concerning use of the device in a safe way and
understand the hazards involved.
Electrical devices are not toys. Always keep and use the device out of the reach of very
young children.
Children must be supervised to ensure that they do not play with the device.
Cleaning and user maintenance shall not be made by children without supervision.
CAUTION! Electrocution hazard
Do not operate the device if it is visibly damaged.
Observe that parts of the device may still conduct voltage even if a fuse has blown.
Do not use the device in wet conditions or submerge in any liquid. Store in a dry place.
Only use accessories that are recommended by the manufacturer.
Do not modify or adapt any of the components in any way.
CAUTION! Damage hazard
Before start-up, check that the voltage specification on the data plate is the same as that of
the power supply.
Ensure that other objects cannot cause a short circuit at the contacts of the device.
Ensure that the negative and positive poles never come into contact.
Installing the device safely
WARNING! Electrocution hazard
Lay the cables so that they cannot be damaged by the doors or the hood.
Crushed cables can lead to serious injury.
CAUTION! Suffocation hazard
Install the device in a well ventilated area.
CAUTION! Risk of injury
Ensure that the device is securely fastened so that it cannot get loose under any circum-
stances (e. g. sudden braking, accidents) and cause injury to the occupants of the vehicle.
When positioning the device, ensure that all cables are suitably secured to avoid any form
of trip hazard.
NOTICE! Damage hazard
Do not place the device near heat sources (heaters, direct sunlight, gas ovens, etc.).
Set up the device in a dry location where it is protected against splashing water.
Use ductwork or cable ducts if it is necessary to lay cables through metal panels or other
panels with sharp edges.
Do not lay the cables so that it is loose or heavily kinked.
Do not pull on the cables.
4

Publicité

loading