Inventum IKA8035 Manuel D'installation page 32

6. To attach the carbon filter, push it down until it clicks.
Caution:
Make sure that the carbon filter cover is installed correctly.
7. Put the grease filter in the cavity of the induction plate.
8. Put the grille on top of the grease filter.
INSTALL THE AIR EXHAUST PIPES FOR EXTRACTION
If you use the extraction method, you must install the air exhaust duct. To install the air exhaust duct, do the steps
that follow.
1. Make sure that the air exhaust is as straight and as short as possible. If you use long pipes with lots of bends
or if you use pipes with a diameter smaller than the outlet of the motor, you decrease the performance of the
appliance and increase the noise that is produced.
2. Follow the installation instructions of the manufacturer of the pipes.
CONNECT THE APPLIANCE
1. Obey the safety instructions for the electrical connection. Refer to the section
connection .
2. Install the appliance to a regular omnipolar isolating switch with a minimum opening of 3mm between the
contacts to assure the complete disconnection of the mains supply under category III over-voltage conditions.
3. Connect the appliance to the mains supply.
After connecting the display of the appliance lights up for a short time. The appliance is ready for use.
SET THE HOOD OPERATION MODE
The default mode of the appliance is the air extraction mode. To select the air recirculation mode, do the steps that
follow.
1. Make sure that the appliance is in the power-off state.
2. Press the child lock button for 3 seconds. The letter Lo will appear on the operation indicator when the appliance
is locked.
3. Press the automatic synchronisation button for 3 seconds. The buzzer sounds.
• The letters OU will appear on the operation indicator if the appliance is in air extraction mode.
• The letters IN will appear on the operation indicator if the appliance is in air recirculation mode.
4. Press the child lock button to change the operation mode.
5. Press the on/off button to set the operation mode. The appliance turns on.
SET THE MAXIMUM POWER
Setting the power management
Use the power management mode to set the total maximum power of the appliance.
Note:
As a default, the appliance is set to 7.4 kW. The possible settings are: 2.8, 3.5, 4.5, 5.5 or 7.4 kW.
1. Do not turn on the appliance. Activate the child lock in the power off state.
2. Press the rear left Boost button for 3 seconds. The buzzer sounds.
3. Press the front left Boost button for 3 seconds. The buzzer sounds and the current value appears.
• The letters PO will appear in the operation indicator of the rear left cooking zone.
• The digits 74 will appear in the operation indicator of the front left cooking zone.
• The digits 00 will appear in the operation indicator of the front right cooking zone.
32 • English
Safety instructions for the electrical