Publicité
Les langues disponibles
Les langues disponibles
4
4
Press the mode switch and select the desired
water jet mode.
• The mode indicator will glow the previously selected mode. If
the appliance is not used for more than 30 days, or after the
appliance has been fully charged from its fully discharged
state, the mode is initialized to AIR IN (SOFT). (When the
battery is drained, the mode will be reset but this is not a fault.)
• If you want to use a different mode, press the mode switch
until it changes to the desired setting. Pressing the mode
switch will change the mode from AIR IN (SOFT) to AIR IN
(REGULAR) to JET to INTERDENTAL.
Mode
INTERDENTAL mode (indicator blinks)
• A fully filled water tank provides
approximately 2 minutes of use.
This mode is for concentrated care of the
zones between the teeth with intermittent
water flow.
JET mode (indicator glows)
• A fully filled water tank provides approximately
35 seconds of use.
This mode is for concentrated care of the
zones between the teeth with strong water flow.
AIR IN (REGULAR) mode
• This mode is for periodontal pocket cleaning
and gum care.
AIR IN (SOFT) mode
• This mode is for gently massaging the gums.
All manuals and user guides at all-guides.com
Description
Notes
• When you use the appliance for the first time, press the
power switch to turn the appliance on and test each of the
water jet modes with the tank filled with water.
• The appliance may not operate in an ambient temperature
approximately 5 °C or lower.
• Do not hold the tip of the nozzle firmly against the teeth or
gums.
• Since plaque adhering to the surface of teeth cannot be
removed only with water flow, brushing is always
necessary. It is recommended to clean inside your mouth
with water flow after brushing your teeth.
• Do not operate the main unit when empty other than when
pouring out any remaining water after use. Operating the
main unit without water may result in a malfunction.
5
5
Place the nozzle in your
mouth and close your mouth
gently before pressing the
power switch.
• To use, place your face over a
washbasin, and with the main unit
upright and the nozzle at the top,
raise your elbow.
• Pressing the mode switch during
use will change the mode.
• If the nozzle is inclined too much,
water will come out of the ventilation
hole instead of the nozzle. (The
ventilation hole in the rear of the
main unit allows for easier water
suction of the hose.)
11
Publicité
